What is the fabric of de-static fabric?
De-static fabric is a functional fabric with pre-static hazards, de-static fabric in weaving is, evenly mixed with conductive fibers and woven into the fabric. Conductive fiber is a general term for fiber made wholly or partially of conductive or sub-conductive material of metal or organic matter, whose volume resistivity PV is between 104-109 ohms. The vast majority of protective clothing made of de-static fabric adopts special polyester filament/elastic yarn, warp or weft embedded conductive fibers, woven by a very process. This fabric than the traditional antistatic agent manufacturing protective clothing not only has good dustproof performance, the effect of static is enhanced several times, the conductive wire will not break, due to good dustproof performance, so greatly reduce the number of cleaning. Is the fabric of choice for most de-static protective clothing.
The nature of de-static workwear and the mechanism of elimination of electricity
In the chemical fiber fabric with conductive fiber made of de-static workwear, itself does not produce dust does not fall off, not easy to carry micro-dust, the unique design also prevents the intrusion of dust. It is not easy to carry micro-dust, and the unique design also prevents the invasion of dust. Its dissipation is based on two mechanisms of charge leakage and neutralization. When grounded, the static electricity on the fabric in addition to the conductive fiber corona discharge is neutralized, but also by the conductive fiber to the earth discharge; not grounded with the conductive fiber of the weak corona discharge and dissipate electricity. Practice has proved that the de-static workwear can effectively inhibit the workwear static electricity, remove or reduce the harm of electrostatic discharge.
The use of de-static clothing
Cleaning cycle: once a week
Use life: normal use and professional cleaning under the premise of cleaning more than 50 times
1. To avoid the metal sharp edge scratching the fabric, resulting in the breakage of the workwear fabric.
2. In order to reduce the dustiness of the fabric and the shielding of the dust, our company adopts the chain stitch method of sewing, prevent the sharp tool from hooking the stitching when using and cleaning, so as not to cause off the needle and affect the use.
3. When cleaning dust-free, clothing with zipper should be zipped up to reduce winding and to avoid abnormal damage to the zipper.
4. When cleaning to use the special love and care tape bonded securely with the adhesive buckle, so as to avoid winding or prickly surface mechanical damage to the workwear fabric.
5. Avoid brushing with brushes to avoid damaging the clothing fabric.
The way to clean the electrostatic fabric
Industrial production (such as finished electricity, semiconductor, perimeter finishing, injection molding, pharmaceutical, etc.) process, clean room there are many potential sources of pollution, which is a big threat is also simple to be manipulated that is the personnel pollution factors, people in the clean room activities will produce a large number of dust particles, including: 1, active dust particles: such as bacteria and yeast, etc.; 2, inactive dust particles: such as hair, dander, etc.; 3, chemical substances: such as na, potassium magnesium, etc. At present, the effective method is to take away the dust particles through clean room workwear isolation cleaning, so that the pollutants are not dispersed to the clean room environment, in order to reduce the pollution of the clean room environment by personnel. The governance of clean clothing system occupies an important position in the pollution manipulation of clean room. Usually, clean and de-static workwear is cleaned once a week, and some demanding environments require daily cleaning, even every time you enter the clean room to change the clean clean clean clothes. Finish tube fiber itself is very difficult to get dirty clean fiber, but how to maintain is an important factor, that is, with the method of cleaning. If the general cleaning method is adopted, of course, it will be dirty. So it is necessary to use the extraordinary method. Clean workwear, from the governance aspect, must also be cleaned and packed in the clean room when cleaning. As an important means of contamination manipulation, the cleanliness of clean clothing is required to be particularly high.
The following are particularly important points when cleaning
1. Before cleaning, the abrasion, damage and buckle and other accessories should be inspected, and those with defects should be repaired, replaced or scrapped.
2. Must be cleaned, dried and bundled in a clean room with higher cleanliness than that of the clean room using workwear.
3 The temperature of cleaning should not exceed 40 degrees, and the temperature of drying should not exceed 60 degrees
4. In the post-rinsing permeability, antistatic agents can be used to improve the antistatic properties, but the antistatic agent selected should be well combined with the fiber, no dust off.
5. The workwear with buckle should be washed under the buckle state.
Technology Co., Ltd.--Professional integrated service provider of functional fabric supply and application. The company has strong scientific and technological research and development strength, advanced production and inspection means, and has the right of self-supporting import and export. It is also an ISO9001-2008 and ISO4001-2004 certified enterprise. The main products are: de-static series, high temperature resistant fireproof series, fireproof series, oil and water resistant series, acid and alkali resistant series, general workwear fabrics and auxiliary materials, etc.. Involved in metallurgy, fire fighting, petroleum, chemical, machinery, medical and other industries. Decades of dedication, market-oriented, innovation as the driving force, quality for survival, has progressed to grow. Technology to provide you with a full range of solutions and perfect products and services.
Technology Co., Ltd - a professional integrated service provider for the supply and application of functional fabrics. The company has strong scientific and technological research and development strength, advanced production and inspection means, and has the right to import and export. We are also an ISO9001-2008 and ISO4001-2004 certified enterprise. The main products are: de-static series, high temperature resistant fireproof series, fireproof series, oil and water resistant series, acid and alkali resistant series, general workwear fabrics and auxiliary materials, etc.. Involved in metallurgy, fire fighting, petroleum, chemical, machinery, medical and other industries. Decades of dedication, market-oriented, innovation as the driving force, quality for survival, has progressed to grow. Technology to provide you with a full range of solutions and perfect products and services.
Contact: Jeanne yang（MISS）
E-mail: [email protected]
Add: Room A2216/A2217,Double-Star Building,No 567 New South Middle Road, KunShan City JiangSu Province ,China.